DataDirect Networks S2A9550, User Manual

Page: 88 / 118

76
D a t a D i r e c t N e t w o r k s S 2 A 9 5 5 0 U s e r G u i d e
M a n a g i n g t h e S 2 A 9 5 5 0
The
CONSOLE BAUD
command can be used to change the baud rate of the CONFIG port of the
S2A9550
(Figure 3-64)
.
3.8.5 CLI/Telnet Session Control Settings
You may change the CLI's (and Telnet's) various session control settings. The
SETTINGS
command
will display the current setting
(Figure 3-65)
.
The
SETTINGS DEFAULTS
command will reset all the CLI and Telnet session control settings to their
default values.
The
SETTINGS LINES=<number of lines>
command lets you display or set the number of lines
displayed at a time in a page of screen information. Pages provide a way to control the amount of
information displayed to the user at one time. You will be prompted to either press a specified key in
order to scroll from one page to the next, or, (in certain circumstances) to terminate the display
entirely. Valid range is 0 to 512 lines, where 0 indicates that no paging is to be performed on the output
information. Default setting is 0.
Figure 3-64 Changing the Baud Rate
S2A [1]: console baud
Select the new serial console baud rate from choices below:
1 - 9600
2 - 19200
3 - 38400
4 - 57600
5 - 115200 <- Current setting
e - escape out of this command
Enter selection:
Figure 3-65 Current Session Control Settings
S2A [1]: settings
Current Session Control Settings
---------------------------------------------------------------------
Lines per page: 0 (No paging - continuous scroll)