DataDirect Networks S2A9550, User Manual

Page: 86 / 118

74
D a t a D i r e c t N e t w o r k s S 2 A 9 5 5 0 U s e r G u i d e
M a n a g i n g t h e S 2 A 9 5 5 0
3.8 Other Utilities
3.8.1 APC UPS SNMP Trap Monitor
The
APC_UPS
command will display the status of the APC UPS SNMP trap monitor
(Figure 3-59)
.
To enable/disable this monitor, enter command:
APC_UPS MONITOR=ON|OFF
The APC_UPS CLEAR_FAULTS command will delete all pending APC UPS faults from the fault list.
All APC UPS events that disabled writeback caching will be cleared.
3.8.2 API Server Connections
The API command displays the current status of the API connections
(Figure 3-60)
.
To temporarily enable/disable the establishment of connections to the API server, issue command:
API=ENABLE|DISABLE
When disabled, users at remote locations will be unable to establish a new API connection until an
API ENABLE command is issued. Note that this command only provides control over API
connections during the current power cycle. To permanently disable or enable API connections,
across power-cycles, use the
NETWORK API_SERVER command. Default setting for this command
is enabled.
To display the collected statistics on API connections
(Figure 3-61)
, enter command: API STATS
The command API CLEARSTATS will reset the collected statistics.
Figure 3-59 Displaying APC UPS SNMP Trap Monitor Status
S2A [1]: apc_ups
APC UPS SNMP trap monitor is off.
No APC UPS faults detected via SNMP trap.
Figure 3-60 Displaying Status of API Connections
S2A [1]: api
API Server connections are currently -- ENABLED--
Figure 3-61 API Server Connection Statistics
S2A [1]: api stats
API Server Connections Statistics
=================================
Time Date
-------- -----------
System Boot-Up Completion : 18:12:47 02/16/2005
System’s Current : 20:27:17 02/20/2005
API Server Initiation : 18:22:46 02/16/2005
API Server Connections have been : -- ENABLED --
since : 18:12:46 02/16/2005
API Server services have been :
Enabled : 1 time.
Disabled : 0 times.