Data General AViiON 4600 Series, Customer Documentation

Page: 246 / 266

Solving Power–Up Problems
C-10
014–002091
If your computer system displays an error message or hangs during powerup testing,
complete the following steps.
1. Write down any text and the error code number that appears on the screen. If no
error message appears, write down the last letter or number of the testing
message displayed.
2. Turn off the computer unit's power.
3. Wait at least 30 seconds.
4. Turn on power to the computer unit again. If the problem repeats, contact Data
General as described in the Preface.
Exiting the Installer System
If you intend to run a hardware acceptance test or change configuration parameters
before installing DG/UX, you must first exit the DG/UX installer system. Follow the
steps below to leave DG/UX without building a kernel under the present configuration.
1. Enter (for no) to the initial installer prompts, as shown in Figure CĆ2.
2. Halt the system at the DG/UX prompt, as shown in Figure CĆ2.
Do you want to configure any nonstandard devices? [no]
....
....
....
....
....
(Initial installation messages requiring no response)
Set up packages? [yes]
Build kernel? [yes]
Reboot now? [yes]
....
....
....
....
....
(Initial installation messages requiring no response)
#
............................................................................................
............................................................................................
scm>
Figure C-2 Exiting the DG/UX Installation Sequence