Illustration 4.22:
Step 4
: Power up the unit and press the [Off]
button. In this state, the motor should not rotate.
Press [Off] to stop the motor at any time. Note
that the LED on the [OFF] button should be lit. If
alarms or warnings are flashing, please see chap-
ter 7 for more information.
Illustration 4.23:
Step 5
: By pressing the [Hand on] button, the
LED above the button should be lit and the motor
may rotate.
Illustration 4.24:
Step 6:
The speed of the motor can be seen in
the LCP. It can be adjusted by pushing the up
▲
and down arrow buttons.
▼
Illustration 4.25:
Step 7
: To move the cursor, use the left and
◄
right arrow buttons. This enables speed changes
►
by larger increments.
VLT
®
HVAC Drive Instruction Manual
4. Electrical installation
MG.11.A4.22 - VLT
®
is a registered Danfoss trademark
43
4