All parameter settings are now transferred to the frequency converter.
A separate manual for MCT 10 Set-up Software is available
: MG.
10.Rx.yy
.
The MCT 10 Set-up software modules
The following modules are included in the software package.
MCT Set-up 10 Software
Setting parameters
Copy to and from frequency converters
Documentation and print out of parameter set-
tings incl. diagrams
Ext. user interface
Preventive Maintenance Schedule
Clock settings
Timed Action Programming
Smart Logic Controller Set-up
Ordering number:
Please order the CD containing MCT 10 Set-up Software using code
number 130B1000.
MCT 10 can also be downloaded from the Danfoss Internet:
WWW.DANFOSS.COM, Business Area: Motion Controls
.
5.1.6 Tips and Tricks
•
For the majority of HVAC applications the Quick Menu, Quick
Set-up and Function Set-up provides the simplest and quickest
access to all the typical parameters required
•
Whenever possible, performing an AMA, will ensure best shaft
performance
•
Contrast of the display can be adjusted by pressing [Status]
and [
▲
] for darker display or by pressing [Status] and [
▼
] for
brighter display
•
Under [Quick Menu] and [Changes Made] all parameters that
have been changed from factory settings are displayed
•
Press and hold [Main Menu] key for 3 seconds for access to
any parameter
•
For service purposes it is recommended to copy all parameters
to the LCP, see par. 0-50
LCP Copy
for further information
5.1.7 Quick Transfer of Parameter Settings when Using GLCP
Once the set-up of a frequency converter is complete, it is recommen-
ded to store (backup) the parameter settings in the GLCP or on a PC
via MCT 10 Set-up Software Tool.
Stop the motor before performing any of these oper-
ations.
Data storage in LCP:
1.
Go to par. 0-50
LCP Copy
2.
Press the [OK] key
3.
Select “All to LCP”
4.
Press the [OK] key
All parameter settings are now stored in the GLCP indicated by the pro-
gress bar. When 100% is reached, press [OK].
The GLCP can now be connected to another frequency converter and
the parameter settings copied to this frequency converter.
Data transfer from LCP to Frequency converter:
1.
Go to par. 0-50
LCP Copy
2.
Press the [OK] key
3.
Select “All from LCP”
4.
Press the [OK] key
The parameter settings stored in the GLCP are now transferred to the
frequency converter indicated by the progress bar. When 100% is
reached, press [OK].
5 How to Operate the Frequency Converter
VLT HVAC Drive High Power Operating In-
structions
88
MG.11.F3.02 - VLT
®
is a registered Danfoss trademark
5