Operation guide | iSave 40
84
180R9239 | AQ299555093252en-001601 | iSave 40 | 09.2022
17. Install the screws and cross tighten
them to the torque specified in the
exploded view. Use the special tool when
using the torque wrench.
The shaft is normally not a wear part
and can only be changed by Danfoss.
1.
Assemble new back-up rings and
O-rings on the valve plates. Back-up
rings first.
2.
Lubricate the O-rings and back-up rings
with clean filtered water and position the
two valve plates into the rotor ends.
9.
Assembling the
cylinder barrol in
pressure exchanger
3.
Using the tools provided gently screw in
the valve plates.
4.
Check the distance between the two
valve plates and the cylinder barrel.
Adjust the distance if necessary.
O-ring
Back-up ring
Special tool