![background image](http://html1.mh-extra.com/html/danfoss/isave-40/isave-40_operation-manual_3540938051.webp)
Operation guide | iSave 40
51
180R9239 | AQ299555093252en-001601 | iSave 40 | 09.2022
Instruction | Right and wrong - Hose assembly routing tips
5
180R9434 | AN375455762639en-000201 | 07.2021
The use of pipe or fittings between pump
and iSave connectors and hoses should
be avoided. Such configurations can apply
excessive loads on the connectors and can
cause connector and/or connector bolt
failure. If this cannot be avoided, the piping
system must be protected by either hose
whip restraints mounted directly to the
frame or the hard piping must be fixed rela-
tive to any pump/iSave movements.
If hose is bent, ensure max. bending angle
and distance S from each connector (see
table 1 on page 6).
WRONG
RIGHT
To prevent hose collapse and flow restriction,
hose bend radii should be kept as large as
possible. Tight bends can also compromise
the hose reinforcement and cause premature
hose failure. Refer to hose specification table
on page 6 for minimum bend radii.
WRONG
HIGH
PRESSURE
NO
PRESSURE
To allow the hose to expand when
pressurized, clamps should not be used at
bends. If possible, do not clamp high and
low pressure lines together.
RIGHT
MAX.
BENDING
ANGLE
WRONG
RIGHT
The hose must have a distance S before
bending starts.
NO
PRESSURE
HIGH
PRESSURE