Index
Remove the old thumb turn on your
door, but please keep the screws that
held it for later use.
In the box you will find 2 tailpiece
extenders for flat and square
tailpieces, making your danalock
fit most deadbolts.
Now fasten the baseplate
with the screws that original
ly held the thumb turn and
cylinder piece.
Important! The cylinder tailpiece have to align with the
door surface.
Extend the tailpiece with one of the two
extenders before you mount the baseplate. The tailpiece
extender should stick out 10 mm from the baseplate.
Click the lid off your danalock with your
nails, or loosen the lid by gently turning
a screwdriver in the slot at the rim of
the shell.
Place your danalock on the base, be
sure the cylinder tailpiece fits in the
center.
Fasten the 3 base-screws.
Click the lid back on. Now Your
danalock is now ready for use.
10 mm
align with
the door
surface
The danalock comes with batteries inserted, but a thin plastic folio
guarantee that your new danalock is fully charged. Remove the folio
and the danalock lits up with a green light for 5-10 seconds.
Loosen the 3 base-screws placed right underneath the
printed circuit board with a screwdriver.
14
danalock App:
Install new lock
Install new lock
Press “Add new lock”.
This will make the app
start looking for any
danalocks in the area.
First you need to go to
your danlock on your
door. Stand in front of
the lock so the signal
will be clear.
Choose your new lock. When the App
finds your danalock it will be listed on
the screen. Now press “Install”
Next step is to give your lock a name.
Press the arrow when you are done.
A welcome screen opens up.
Now you can configure your
lock-settings in detail: Power-saving,
turn-settings, battery-level and much
more. Read more here.
It is important that you save to the
lock each time you make choice or a
change. You can also choose to add
your lock to the keychain and make
your adjustments to the settings later.
