![background image](http://html1.mh-extra.com/html/daikin/bycq140cgw1/bycq140cgw1_installation-manual_2460456007.webp)
English
6
Note
Tighten the screws securely, or otherwise a defect as shown
•
below may result.
Readjust the height of the indoor unit if there is a space between
•
the ceiling and panel with the screws tightened securely.
Air
leakage
Air leakage
from the
ceiling side.
Generation
of dirt
Drew condensation
or dripping
Make sure that there is no space.
Height adjustments to the unit
will be possible through the
holes on the corners of the
panels without removing the
panel, provided that the
adjustments does not affect the
levelness or the drain piping of
the indoor unit. Refer to the
installation manual of the indoor
unit to conduct the work.
Checking panel.
6-3
Draw the harness and lead wires (on the panel side).
(1)
Panel
Harness
Harness
Lead wire
(on the panel side)
Lead wire
(on the panel side)
Connect the connector of the lead wires and move the glass
(2)
tube to cover the connector part.
Lead wire
(on the panel side)
Harness
Connector
Be sure to connect
them securely.
Move the
glass tube.
1
2
Glass tube
Tighten and secure both ends of the glass tube with the
(3)
clamps on the glass tube together with provided clamps
(accessories (5)). Cut the redundant portions of the clamps
from their roots after the both ends are secured.
Tighten the clamps
Cut the roots
Clamp
(accessory (5))
Return the connected lead wires to the space between the
(4)
indoor unit and panel.
(Accommodate the lead wires in the shaded part shown in the
illustration.)
Note
Accommodate the lead wires carefully so that the lead wires
will not come in contact with the air fi lter.
Connected
lead wires
Connected
lead wires
Panel
EL. COMPO. BOX
of the indoor unit
Insert the seal (accessory (8)).
(5)
Insert the seal until
the seal comes in
contact with the
claw.
Claw
Seal
(accessory (8))
Attaching dust box.
6-4
Panel clasp
PIPING SIDE
engraved mark
DRAIN SIDE
engraved mark
Panel
Fall prevention
cord
Dust box
Mount the dust box
with the side where
the mark is engraved
faced downward.
2
1
Hook the fall prevention cord for the dust box to the panel
(1)
clasp as shown in the illustration.
Panel
Hooked
Dust box
Clasp
Fall prevention cord
Exhaust opening on dust box
Attach the dust box in the order opposite to the procedure in
(2)
4-3
under
“4. PREPARATIONS FOR PANEL”
.
Note
Make sure that the fall prevention cord is not caught by the
exhaust opening on the dust box when attaching the dust box.
Otherwise, the dust box may not function normally.
01_EN_3P257556-1.indd 6
01_EN_3P257556-1.indd 6
9/3/2009 4:05:07 PM
9/3/2009 4:05:07 PM