9
English
Press fi t the fl exible hose connected in (3) into the panel.
(4)
Pay attention so that the hose will not be caught by the suction
grille closed.
Flexible
hose
To suction grille
Press fit the
flexible hose
along the shape
of the corner.
Connect the opposite end of the fl exible hose connected in (3)
(5)
onto the suction grille side.
Rotate the fl exible hose joint on the suction grille side
*
according to the mounting direction of the suction grille as
shown in the illustration.
Flexible hose joint on
the suction grille side
Connect the
hose securely.
Flexible hose
joint on the
suction grille side
Flexible hose
Note
Check that the claws are engaged securely. Otherwise, a dust
collection failure may result.
Push up the suction grille slowly fi rst, and while pressing the
(6)
two knobs, fi nally fi t the grille into the panel securely.
Panel
Knobs
(2 points)
Suction grille
Note
The suction grille can catch the fall prevention cords while the
suction grill is closed.
Check that the fall prevention cords do not protrude from the
suction grille before closing the suction grille.
Suction grille
Must not protrude
Fall prevention
cord
Attaching decoration corner covers.
7-4
Connect the decoration corner cover (with the display)
(1)
securely to the PCB in the order opposite to the procedure in
“4. PREPARATIONS FOR PANEL”
.
2 Cover
3 Screw
1
Lead
wires
Connector
Connect the
connector
securely.
PCB
Decoration corner
cover (with display)
Clamp
Arrange the lead wires
neatly so that the clamp
will be on the inner side
of the cover.
Attach the decoration corner cover (with the display) to the
(2)
corner with the DRAIN SIDE engraved mark. Push the
connected lead wires through the corner hole onto the
backside of the ceiling.
Press fit the five claws on the
decoration corner cover into
the holes on the panel.
Decoration corner
cover (with display)
Lead wires
DRAIN SIDE
engraved mark
Hook each of the cords of the remaining decoration corner
(3)
covers (i.e., three covers) onto the corresponding pin on the
panel.
Pin
Attach the decoration corner covers (i.e., the three covers) to
(4)
the panel.
Press fit the five claws on the decoration
corner cover into the holes on the panel.
01_EN_3P257556-1.indd 9
01_EN_3P257556-1.indd 9
9/3/2009 4:05:36 PM
9/3/2009 4:05:36 PM