English
4
Turn the two fi xing knobs of the dust box.
(1)
Dust box
(The front side of the panel is shown for ease of explanation.)
Fixing knob
Fixing knob
Remove the dust box from the panel while paying attention not
(2)
to cut the fall prevention cord.
Dust box
Fall prevention cord
2
1
Remove the fall prevention cord for the dust box from the clasp
(3)
bracket of the panel.
Remove the fall
prevention cord from
the clasp bracket.
Clasp
Dust box
Fall prevention cord
Panel
PREPARATIONS FOR INDOOR UNIT
5.
WARNING
Check that the indoor and outdoor units are turned power off
before conducting wiring work.
Otherwise, an electric shock may be received.
CAUTION
Conduct the following work after installing the indoor unit.
•
Install the indoor unit according to the installation manual
•
provided with the indoor unit.
Attaching spacer (accessory (1)).
5-1
Indoor unit
Remove the bypass hole closure material, and peel off the
(1)
seal and holding tape.
3
2
Seal
3 Holding tape
Indoor unit
1
Screws
(2 points)
Claws (4 points)
Pinch both ends and
disconnect the four
claws for removal.
Bypass hole
closure material
Peel off the release paper of the double-stick tape on the
(2)
backside of the spacer (accessory (1)).
Attach the spacer (accessory (1)) on the air bypass hole.
(3)
Check that the air bypass hole is not blocked after the spacer
is attached.
Air bypass hole
Pasted to align with the
air bypass hole.
Align the corners.
Spacer
(accessory (1))
Attaching harness (accessory (4)).
5-2
Remove the EL. COMPO. BOX lid from the indoor unit.
(1)
Claws
EL. COMPO. BOX lid
Screws
(2 points)
Loosen the screws (in two points) and slide the EL. COMPO. BOX
lid in the direction of the arrow to unhook the lid from the claws.
01_EN_3P257556-1.indd 4
01_EN_3P257556-1.indd 4
9/3/2009 4:04:54 PM
9/3/2009 4:04:54 PM
