Daikin Altherma EVLQ05+08CA, Installer'S Reference Manual

Page: 110 / 252

7 | Installation
Installer reference guide
110
EHYH EHYHBH/X08AF + EHYKOMB33AA
Daikin Altherma hybrid heat pump
4P355634-1F – 2020.10
Terminal position Minimum distance
(mm)
I From a terminal discharging towards another
terminal 1200
J From an opening in a car port (e.g. door,
window) into a dwelling
K Vertically from a terminal on the same wall 1500
L Horizontally from a terminal on the same wall 300
M Above an opening, air brick, opening windows,
etc.
N Horizontally to an opening, air brick, opening
windows, etc.
P Above roof level (to base terminal)
Q From an adjacent wall to flue
R From an adjacent opening window 1000
S From another roof terminal 600
- From an external boundary. Note: If the
terminal is facing a boundary, it is
recommended that an anti-plume kit be fitted.
T
T1
T2
Terminals adjacent to windows or openings on
pitched and flat roofs: The flue should NOT
penetrate this area.
2000
600
NOTICE
The boiler manufacturer cannot be held responsible for atmospheric conditions
when siting flue terminals.
CAUTION
Once the flue system has been installed and the appliance commissioned, the
installer should observe the plume direction. Particular attention should be drawn to
plume vapour reentering the gas boiler via the air intake. If this occurs, it is highly
possible the flue is fitted with a negative pressure area and therefore a plume
management kit MUST be fitted.
7.13.7 Insulation of the gas exhaust and air intake
Condensation may occur on the outside of the pipe material when the material
temperature is low and the environment temperature is high with a high humidity.
Use 10 mm damp-proof insulation material when there is a risk of condensation.
7.13.8 Fitting a horizontal flue system
The 60/100 mm horizontal flue system may be extended up to a maximum length
as specified in the table indicating the maximum pipe lengths. Calculate the
equivalent length according to the specifications in this manual.