Web Operation 76
Parameter
Description
Ethernet Mode
The default setting is single NIC.
Single NIC: Two Ethernet cards are used independently. Request
HTTP, RTSP and other services of the device through net card 1
or net card 2. You need to configure one default net card (net card
1 by default), to request network services launched by the device,
including DHCP, Email and FTP. During network status detection,
the network is deemed to be disconnected if one net card is
disconnected.
Fault tolerance: Two Ethernet cards use one IP address, and only
one Ethernet card works under normal conditions. If working
Ethernet card breaks down, the other Ethernet card is enabled
automatically to ensure smooth network. It is deemed that the
network is disconnected only when both Ethernet cards are
disconnected during network status check. Both Ethernet cards
need to be in the same LAN.
Load balance: Two Ethernet cards use one IP address, and all of
them work together to bear network load; the bound network
throughputs are basically the same. If one Ethernet card breaks
down, the other Ethernet card works normally. It is deemed that
the network is disconnected only when both Ethernet cards are
disconnected during network status check. Both Ethernet cards
need to be in the same LAN.
Link aggregation: The system uses NIC bonding to realize
communication function. All bonded NICs are working together
and bearing the network load. The system allocates the
corresponding ports to the specified switches according to the port
load setting. Once one port link malfunctions, the system stops
sending out data from current port. The system can calculate the
new load and specify the new port(s) to send out data. The system
calculates again to specify the port(s) once the malfunction port
becomes available.
Single NIC device does not support Ethernet mode selection. The
actual device shall prevail.
IP Version
It is IPv4 by default.
MAC Address
Displays the MAC address of the Device.