28
Click
Stop
to stop the pan.
3.2.2.2.6
Configuring PTZ Speed
PTZ speed is determined by two factors—firstly and basically, the speed level (low, middle and high,
marked by
①
in Figure 3-20); secondly, the control panel’s speed value (1, 2, 3…8 marked by
②
in
Figure 3-20). If you select
Low
as the
PTZ Speed
①
, then according to the maximum
Low
value, the
Speed
②
will be divided into 8 parts, and it’s the same for you to select
Middle
or
High
as the
PTZ
Speed
①
.
Select
Setting > PTZ > Function > PTZ Speed
.
Step 1
The
PTZ Speed
interface is displayed. See Figure 3-20.
PTZ speed
Figure 3-20
Select from
Low
,
Middle
and
High
. The configuration takes effect immediately.
Step 2
3.2.2.2.7
Configuring Idle Motion
Enable this function. And when there is a time period when PTZ does not receive any instructions,
motions you have already set will be implemented.
Preparation
You have configured preset, tour, scan and pattern before configuring idle motion.
Procedure
Select
Setting > PTZ > Function > Idle Motion
.
Step 1
The
Idle Motion
interface is displayed. See Figure 3-21.
