User’s Manual
35
Parameter
Description
Enable ARP/Ping to
set IP address service
Select the check box, get the camera MAC address, and then you
can modify and configure the device IP address with ARP/ping
command.
This is enabled by default. During reboot, you will have no more
than 2 minutes to configure the device IP address by a ping packet
with certain length. The server will be turned off in 2 minutes, or it
will be turned off immediately after the IP address is successfully
configured. If this is not enabled, the IP address cannot be
configured with ping packet.
A demonstration of configuring IP address with ARP/Ping.
1. Keep the camera that needs to be configured and the PC within
the same local network, and then get a usable IP address.
2. Get the MAC address of the camera from device label.
3. Open command editor on the PC and enter the following
command.
4. Restart the camera.
5. Check the PC command line, if it outputs information such as
Reply from 192.168.0.125…
which means the setting is
completed.
6. Enter http://(IP address) in the browser address bar to log in.
Step 3 Click
Save
.