DAGON Lighting
SPL-3 –
RGB LED strip driver – DMX-512 and others
17
The brightness of colours is determined by codes 571 ... 579.
For code 571 is the lowest brightness and highest for code 579.
Additionally, code 570 allows control the brightness of light by means of an analogue signal
0-10V given to input IN B to the driver SPL-3.
Codes 570 ... 579 described in the instructions point 2.4.
The above-described properties of the driver SPL-3 in RANDOM mode allows control of
the large diversity of LEDs. With a lot of drivers SPL-3, you can configure each one
differently to give the effect of diversity in color and brightness of individual points of light.
RANDOM mode also provides a smooth color transitions. After entering code 500 the
driver's SPL-3 RANDOM mode will change colors in a smooth manner over the entire range
of color (palette is irrelevant or range of colors).
During a smooth change of color in RANDOM mode, there also works features speed
control and brightness changes, the work described above codes 561...569 and 571...579, and
560 and 570 codes to control analog 0-10V at the inputs IN A and IN B SPL-3 driver.
3.3.1
Example configuration of the controller SPL-3 for RANDOM mode.
553 - RANDOM mode operation
019 - chosen color palette number 0 and the color range from 1 to 9 – see tab.3.
650 - no white balance correction
561 - rate of change of color at approximately 40 sec
576 - slightly reduced brightness
These five codes must be entered into the controller SPL-3, to work in a desired manner.
The order of input codes is optional.
3.3.2. Example configuration of the controller SPL-3 for RANDOM mode.
553 - RANDOM mode operation
425 - chosen color palette number 4 and the color range from 2 to 5 – see tab.3.
(red, blue, orange, violet)
650 - no white balance correction
566 - rate of change of color at approximately 1 sec
579 - the maximum brightness
These five codes must be entered into the controller SPL-3, to work in a desired manner.
The order of input codes is optional.