Daewoo Solar 420LC-V, Manual

Page: 78 / 151

S0707260
Page 15
Swing Motor
11. Reposition motor so that end of drive shaft
faces out to one side. Pull out cylinder
block (111) and disassemble pistons (121),
retainer plate (123), spherical bushing
(113), front spacer (117) and shoe plate
(124). Be careful not to make any
scratches or leave nicks on reciprocating
parts.
NOTE:
Record or mark piston position
or store them in order in which
they were removed so that they
can be returned to same
cylinder bores they were taken
out of. Service life could be
extended incrementally by
maintaining previous wear-
pattern relationships by
avoiding new ones.
12. Pull out friction plates (742) and separator
plates (743) from area behind cylinder
block.
13. Remove lock ring (437) from around drive
shaft. Use a large enough pair of snap-ring
pliers to properly tension ring and pull it
away from locking groove.
Use extra caution in pulling off front cover
(304) behind snap ring. Drive shaft oil seal
(491) underneath cover must be replaced
if it is damaged during disassembly. Use a
little bit of extra caution (and a very large
set of channel locks, a puller or extra wide
adjustable wrench) to carefully withdraw
cover straight back off drive shaft.
Figure 15
Figure 16
Figure 17