Daewoo Solar 420LC-V, Manual

Page: 53 / 151

S0705000
Page 10 Cylinders
Return to Master Table of Contents
DISASSEMBLY
1. Following removal of cylinder from
excavator attachment, support cylinder on
some type of sturdy work platform and
drain all oil. Rotate cylinder so that piping
ports are on top, to allow trapped air to
vent.
2. Position piston rod so that it is extended
approximately one half meter (20").
3. Loosen bolts (7) on the end of cylinder.
NOTE:
Wrap a cloth or other protective
material around piston rod, to
avoid possibility of accidentally
scratching or scoring rod
surface while fasteners are
being loosened and removed.
Component parts (numbered in
parentheses) are keyed to
Figure 4.
CAUTION!
Vent air from the hydraulic system before disconnecting cylinder piping connections. Use the
lever on the reservoir, while the engine is running. Discharge the hydraulic accumulator and
vent residual tank pressure after the engine is shut off. Pour clean replacement fluid back into
the system if excessive fluid is lost.
Figure 8
Figure 9
Figure 10