4-3
LUBRICATION SYSTEM
UPPER LINE
PROPER LINE
LOWER LINE
SIGHT GLASS
OIL DRAIN PLUG
OIL PICK
UP COLLAR
OIL FILTER
SCREEN
TAPPET ADJUSTING
HOLE CAP
ENGINE OIL LEVEL INSPECTION
●
Erect the motorcycle on the main stand.
●
Warm up the engine to heat the engine oil to an
appropriate level.
●
Stop the engine, and check the oil level line on the
sight-glass installed on the LH. crank case cover.
●
If the oil level is between the lower and higher sight-
glass oil level line, oil level is satisfactory. If the oil
level is below or near the lower level mark, add the
recommended engine oil.
ENGINE OIL CHANGE
●
Loosen the oil drain plug bolt and drain engine oil.
●
Operate the kick starter arm several times to remove
the remaining oil from the engine.
●
Tighten the oil drain plug bolt.
TORQUE VALUE : 2.0-3.0 kgf
·
m
TORQUE VALUE : 1.5 kgf
·
m
●
Loosen the special screw, remove the plug maintenance
cover.
●
Fill the recommended oil after opening oil filter cap of
cylinder head cover.
OIL CAPACITY : 1.1
ℓ
(After disassembly)
0.9
ℓ
(After Oil change with Oil in
the Oil hose removed)
0.8
ℓ
(After Oil filter change)
0.75
ℓ
(After Oil change)
●
API service classification : SE, SF, SH grade.
●
Start the engine and keep it idle for a few minutes.
●
Stop the engine and check the oil level. If the oil level
is low, add the recommended engine oil.
●
Check on oil leaks.
•
To completely and rapidly drain engine oil, warm up
engine and erect the motorcycle on its side stand.
•
It is extremely important to replace oil filter or clean
the oil filter screen at the first maintenance interval
(after 1,000Km).
•
Clean the oil filter screen every 4,000Km.
•
Clean the filter screen with fresh cleaning oil.
•
Check the hole cap O-ring for satisfactory condition.
•
Tighten the hole cap with specified tightening
torque.
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
OIL FILTER CAP
Summary of Contents for S2 125
