Daedong CK2610CHSE, Manual

Page: 194 / 246

7
-
1
ck2610chse / ck3510(h,c,ch)se / ck4010(h,c,ch)se
tC2O713A
REPlACING TRANsMIssION FlUID AND FIlTER (M)
If transmission fluid is contaminated
or the transmission is repaired, trans-
mission fluid should be changed.
Make sure to replace its filter as well.
also, replace the oil filter at every
200 hours of operation.
1. Park the tractor on a level ground
and start the engine to warm it up.
2. stop the engine, apply the parking
brake and remove the drain plug.
(1) hydraulic filter (2) hst filter
3. To drain the used fluid, place a oil
container under the transmission
case and remove the drain plug to
drain used fluid.
If the fluid does not flow out freely,
unscrew the breather plug on the
side of the hydraulic cylinder on
the left of the top link bracket to
facilitate drainage. reinstall the
drain plugs securely afterward.
4. Unscrew the fluid filter from the rear
right section on the tractor using a
filter wrench.
(1) Drain Plug
tC2O708A
(1) oil Dipstick and filler Port
(a) oil level is acceptable within this range
5. Apply a thin film of clean oil onto
the O-ring of a new filter.
6. Tighten the filter until it touches the
mounting surface. then, tighten
the filter for a half turn further with
a hand.
7. After installing a new filter, run the
engine for a few minutes and stop
it.
8. check the oil level again and add
more oil to the specified level.
tC2O702A
TC220-영문-수출향(법인향)-OM-07.indd 18 2020-01-23 오전 9:19:19