1.1 Important Before You Start
•
Please read entire manual carefully and completely before using.
•
As with any device, failure to carefully read and follow all instructions and safety information
prior to use may result in decreased product performance or failure.
1.2 Safety Warnings
• It is the responsibility of the caregiver to ensure that
the user can operate this product safely.
• Power “OFF” or “STOP” Pneumatic Controller
for cardiac arrest
events. The unit is not intended for use during CPR. (See Section 6)
• Properly route and secure Power Cord and hoses to avoid
trip hazard.
• Maintain accessibility to Power Cord such that it can
be easily unplugged.
• The Dabir System
must be cleaned using the outlined
guidelines within this manual. Cleaning conditions that do not reflect
the recommended cleaning process may result in irreparable
damage.
• Disconnect the
Pneumatic Controller
from the wall power source
prior to cleaning and inspecting.
• Do not immerse or allow liquid to enter any part
of the
Pneumatic Controller
.
• Keep DabirAIR Micropressure Overlay vent free and clear of liquids,
contamination and debris to avoid over inflation.
• Do not operate the
Pneumatic Controller
in the presence
of flammable liquids or gases.
• Only use the DabirAIR
Pneumatic Controller
with manufacturer
approved Overlays and Accessories to ensure proper system
function.
• The DabirAIR Micropressure and DabirAIR Microclimate
products are OVERLAYS, and are not intended to be used
without an underlying support mattress or pad.
• Do not block air intake ports on the bottom of the Pneumatic
Controller or the exhaust vent under the handle.
• Do not place Pneumatic Controller on top of loose articles which may
block air intake ports.
• System must be at room temperature prior to operation. Allow
Pneumatic Controller and Overlay to acclimate to room temperature
for one hour prior to operation.
3
WARNING
: No modification of this
equipment is allowed.
DOC# R01-0006-00004-AA
• Do not place the Pneumatic Controller in direct sunlight.
• The Pneumatic Controller must be stored and operated within
designed operating conditions specified in this manual.
Operating the Pneumatic Controller outside these
ranges may cause damage to the device which could
result in premature failure.
• The Pneumatic Controller must be used with specified operating
wall currents. All other alternative power sources
and currents may result in irreparable damage to
the system and possible hazardous event to the
patient or caregiver.
• Equipment may be hazardous if misused.
• Modification of the device voids warranty and
may compromise intended function. Service should
be performed exclusively by the manufacturer or
manufacturer’s representative.
• If Pneumatic Controller is damaged during the shipping process,
please contact the manufacturer for appropriate action.
• If Pneumatic Controller is dropped during use with noticeable
damage, please remove from service and contact the manufacturer
for appropriate action.
• Do not transport or carry the Pneumatic Controller with an
Overlay attached.
• This device requires the use of a shielded Power Cord
for compliance with emissions limits. Do not operate
device without manufacturer supplied Power Cord.
• Do not use in an MRI environment.
• Turn Dabir System “OFF” during patient transfer and
before patient positioning.
• It is the responsibility of the caregiver to adequately secure and
protect the patient against patient falls.
Summary of Contents for DabirAIR CA-1001
Page 32: ...DOC R01 0006 00004 AA...
