14
3.2 System Installation - Continued
4.
Connect Hose Assembly Connector (Female) to the Overlay Assembly Connector (Male).
Hose / Overlay Connection:
Connection Procedure
With the system powered “OFF” or “STOPPED”, insert the
Overlay Assembly Connector (Male)
into the
Hose Assembly Connector (Female)
(see figure above). An audible “click” can be heard once the connec
-
tors are fully seated. Confirm connector seating with a slight pull.
NOTE:
The connectors must be assembled as shown in the figure below to ensure proper operation. The
device will not function if a positive connection is not made.
Disconnection Procedure
Depress orange button and pull to release
Overlay Assembly Connector (Male)
.
CAUTION:
To avoid depressurization noise, this operation should only be performed
with the Pneumatic Controller powered “OFF” or “STOPPED”.
CAUTION:
To avoid damage, do not over pull on connections or carry the Pneumatic Controller
by the Hose Assembly.
CAUTION:
Do not use petroleum based lubricants on the Overlay Connector Seals.
Use of these lubricants can cause the seals to swell and/or leak.
Hose Assembly
Connector (Female)
Orange Release
Button
Orange Release
Button
Overlay Assembly
Connector (Male)
DOC# R01-0006-00004-AA
Summary of Contents for DabirAIR CA-1001
Page 32: ...DOC R01 0006 00004 AA...
