8
DEVICE SPECIFIC INFORMATION
UV Series
Available Lamps Types & Number of Lamps:
Numerals = Number of Lamps
N/A = Not Available
UVA
Narrow Band
UVB
Broad Band
UVB
UVA / Narrow
Band UVB
12 12
12
N/A
16 16
16
N/A
24
24
24
12 + 12
This section covers topics that are specific to the UV Series.
The Flex Dosimetry or Flex Timer operating instructions are covered on pages sixteen (16) through
twenty-two (22).
UV Series Unpacking & Assembly
The UV Series full-body device is shipped upright in a large cardboard container. Exercise caution as
the fluorescent lamps can be broken if the unit is not unpacked properly.
Using as many people as available but at least two, move the box into the area where the device will
be used. If there are no stairs, and since the unit is on castors, it may be easier to remove it from the
box at the earliest opportunity so that you can simply roll it into position. If there are stairs, you may
consider hiring a professional moving company to move the device into position.
To unpack the unit, first use metal cutters to cut the banding that encircles the package. Use extreme
caution as these bands are under tension and can snap outward when the tension is released. Next,
remove the front cardboard cover. Use a heavy-duty screwdriver to remove the staples. Again be
careful as the staples are sharp and can cause injury. When the front cardboard cover has been
removed, carefully pull the device forward on its castors until it is clear of the box. Take care not to
discard the accessory package which contains your protective eyewear.
Once in position, remove the shipping bars. A ¾” end wrench will be required to loosen and remove
the bolts that hold the shipping bars in place. There is no further assembly required other than to plug
the unit into the appropriate electrical outlet (See Electrical Outlet Requirements below). If your
device is equipped with an optional platform, place the platform inside the machine once it is located
in its final position.
Circuit Breaker
Each UV Series unit is equipped with a circuit breaker that is
located under the frame, at the back right hand side of the
machine. Its location is indicated by the circuit breaker label
(right). When setting up your unit, ensure that the breaker is in
the ON position.
UV Series Electrical Requirements
The number of lamps in a unit determines the voltage, amperage, wire size and outlet necessary to
safely support the unit’s operation. The table and diagrams below define these requirements for each
MAIN DISCONNECT
CIRCUIT BREAKER
l
=
=
ON = RIGHT
O
=
=
OFF
=
LEFT
UV Series
