![background image](http://html1.mh-extra.com/html/daavlin/7-series/7-series_operating-instructions-manual_3057306014.webp)
13
M Series General Information
Available Lamp Types & Number of Lamps:
UVA
Narrow
Band
UVB
Broad
Band
UVB
UVA/
Narrow
Band UVB
UVA/
Broad
Band UVB
10
10
10
6 UVA + 4
UVB
6 UVA + 4
UVB
M Series Unpacking & Assembly Guide
Assembly Instructions
1. With two people, lift the base from its box (the larger of two boxes) and place it where it is to be
used. Be sure to remove all of the accessories, such as the manual, power cord and eyewear
before discarding the box.
2.
Remove the hood from its box (smaller box) and place it on the base with the arched openings
facing front. There is a flange on the bottom of the hood that fits over the upper edge of the fixture.
The hood is designed to fit tightly, so it may take some pressure to seat it properly.
3.
Electrically connect the hood by plugging the electrical cord extending from the back of the hood into
the designated receptacle on the back of the base.
4. Install the power cord by inserting the female “D” shaped receptacle into the corresponding male plug
at the back of the device. Then, plug the unit into any grounded service of the appropriate voltage.
Note: 120-volt, 60 hertz units are shipped with a grounded, three-conductor wall plug. Units
designed for other voltages may be shipped with no wall plug, which would then have to be locally
obtained and installed.
Hood Lamps
The hood lamps have an “ON/OFF” switch so that they can be turned off if desired. When this switch is in
the ON position, the hood lamps will light when the base lamps turn on.
On combination M Series models that have both UVA and UVB lamps, the hood is equipped with UVA
lamps only. The UVA lamps will not operate when UVB is selected.
Special Instructions for Combination Units
With Flex Dosimetry:
If your unit has both UVA and UVB lamps and Integrating Dosimetry, there is
a separate controller for UVA and UVB. Be sure to enter the desired UVA dose into the controller
labeled UVA or the desired UVB dose into the controller labeled UVB.
With Flex Timer:
There is a switch in the center of your control panel that sets the device to either
UVA or UVB operation. Push the switch up for UVA and down for UVB.
All Combination Units:
The UVA lamps will be the first four lamps in the unit. The UVB lamps will
be the last four. Therefore, if you are using the UVA lamps, position your hands or feet at the front of
the device. If using the UVB lamps, place your hands or feet in the back half of the unit.
M Series