15
1 Series General Information
Available Lamp Types (All units equipped with 4 lamps)
y
Narrow Band UVB
y
Broad Band UVB
y
UVA
y
UVA1
y
Blue Light
y
Red Light
y
Intense White Light (SAD)
Unpacking Guide
Open the box at the top and using two hands at each side of the device, pull the 1 Series out of the
box, including the foam packers at each end. Remove the foam.
Be sure that you locate the power cord, manual and eyewear before discarding the shipping box.
Plug the “D” shape female fixture into the corresponding receptacle on the lower left side of the
device. Plug the unit into an appropriate wall outlet. It is now ready for use.
1 Series Electrical Requirements
The 1 Series can be plugged into any grounded, three prong, household electrical outlet.
Note:
120-volt, 60 hertz units are shipped with a grounded, three-conductor wall plug. Units
designed for other voltages may be shipped with no wall plug, which would then have to be locally
obtained and installed.
How to Position Yourself
Hand Treatment: Place the device flat on a table and place your hands directly on the plastic lamp
guard. They should be as close as possible to the center of the fixture for best results.
Larger Area Treatment: Stand the device so that the lamps are perpendicular to the surface on which
the device is standing. Position the part of your body you will be treating eight (8) inches (21cm) away
from the lamps.
Lamp Removal & Replacement Instructions
1. Consult the Lamp Replacement Guide for replacement lamp specifications.
2. Unplug the machine. Then, using a 5/64” Allen wrench, remove the two screws on each side of
the device.
3. Lift off the top of the device (like removing the top from a gift box). The lamps will be exposed.
4. At the end of each lamp is a clear plastic clasp that holds the lamp in position. Press both thumbs
on the outside of the device and use your index fingers to reach to the side of the lamps and pull
the sides of the clasp outward until it releases and the clasp can be removed.
5. Push the red button on top of the lamp socket. The base of the lamp will release. With one hand
near the base and the other near the clasp at the opposite end, grasp the lamp to be removed and
pull both ends upward at the same time until it clears both the clasp and the lampholder/socket.
6. To replace the lamp, reverse the process.
7. Reset the lamp hours following the instructions shown on page twenty-two (22).
1 Series
