![background image](http://html1.mh-extra.com/html/daavlin/7-series/7-series_operating-instructions-manual_3057306011.webp)
10
7 Series & 2 Series General Information
Available Lamp Types & Number of Lamps:
Numerals = Number of lamps
N/A = Not available
UVA Narrow
Band
UVB
Broad
Band
UVB
Doors
with
Lamps
Doors
without
Lamps
N/A 4
4
N/A Optional
6 6 6 N/A Optional
8 8 8 Standard N/A
10 10 10 Standard N/A
This section covers topics that are specific to 7 and 2 Series models. The only differences are the
number, type, and length of lamps and whether or not there are doors. If your device has a “D”
designation, it means that it is equipped with doors but without lamps in the doors. All models
available with Flex Dosimetry or Flex Timer control. The operating instructions are covered on pages
sixteen (16) through twenty-two (22)
7 and 2 Series Unpacking & Assembly
Since the packing box makes a useful work surface for assembly of your device, choose a place close
to where the unit will be installed to unpack it (however, if there are stairs or narrow hallways, it may
be easier to move the device after it has been assembled). In either case, be careful, as the
fluorescent lamps can be broken if the unit is not unpacked properly.
The grid that covers the lamps is not installed for shipping. When the box is unpacked, the grid will be
on top and should be set aside so that it can be installed after the unit is standing.
1. Use a heavy duty screwdriver to remove the staples. Be careful as the staples are sharp and can
cause injury. Remove the top of the box and set it aside. Next, break down the lower end of the
bottom box, exposing the base of the device.
2. Remove the following parts and accessories from the shipping container:
•
Goggles (1 pair) and Glasses (UVA and visible light units only)
•
Feet (2) – Figure 1
•
Stabilizer bars (2) – Figure 2 (7 Series units with doors only – does not apply to 2 Series)
•
Grid
2 Series
7 Series