9
lamp variation. UV Series that are shipped outside the USA and Canada (230 volt units) will require
local installation of a15-amp plug on the end of the cord that meets local electrical standards.
Model
Amps
Wire Gauge
Diagram
Required Outlet
24 lamp, 120 volt
30 amps
10 AWG
A
NEMA L5-30P
16 lamp, 120 volt
20 amps
12 AWG
B
NEMA L5-20P
12 lamp, 120 volt
15 amps
14 AWG
C
NEMA 5-15P
230 volt
15 amps
14 AWG
locally
specified
How to Position Yourself
Enter the unit and close the doors behind you. Center yourself within the unit. As nearly as possible, your
torso should not be closer to any one panel than to another. Standing closer to one of the sides may
cause localized streaking or burning.
UV Series Lamp Removal and Replacement
1) Consult the Lamp Replacement Guide for replacement lamp specifications.
2) Unplug the machine, then using a ¼” hex driver/socket, remove the screw from the bottom of
the grid that is in front of the lamp(s) to be removed.
3) Lift the grid out of the holes in the bottom lamp plate, pull the bottom of the grid toward you,
then lower the grid out of the holes in the top of the unit and set it aside.
4) Grasp the lamp to be removed with both hands and push up until it clears the bottom socket,
then remove the lamp. Reverse the process to install lamps and grid.
5) Reset the lamp hours age to zero. See instructions on page twenty-two (22).
C
B
A
