xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
35
DNS C
OMMANDS
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config dnsr
[[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>]
enable dnsr
{[cache | static]}
disable dnsr
{[cache | static]}
show dnsr
{static}
Each command is listed, in detail, in the following sections.
config dnsr
Purpose
Used to configure the DNS relay function.
Syntax
config dnsr [[primary | secondary] nameserver <ipaddr> | [add |
delete] static <domain_name 32> <ipaddr>]
Description
This command is used to configure the DNS relay function on the Switch.
Parameters
primary
−
Indicates that the IP address below is the address of the
primary DNS server.
secondary
−
Indicates that the IP address below is the address of the
secondary DNS server.
nameserver <ipaddr>
−
The IP address of the DNS nameserver.
[add | delete]
– Indicates whether to add or delete the DNS relay
function.
<domain_name 32>
−
The domain name of the entry.
<ipaddr>
−
The IP address of the entry.
Only
administrator-level users can issue this command.
Restrictions
Example usage:
To set IP address 10.43.21.12 of primary.
DGS-3612G:4#config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
Success
DGS-3612G:4#
Example usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
DGS-3612G:4#config dnsr add static dns1 10.43.21.12
Command: config dnsr add static dns1 10.43.21.12
Success.
DGS-3612G:4#
Example usage:
232
