xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config scheduling
reset the weighted round-robin (
WRR
) cycle of forwarding packets, starting
with the highest available priority class. Priority classes with an equal level of
priority and equal entries in their
max_packet
field will empty their fields
based on hardware priority scheduling.
Parameters
<class_id 0-6>
−
This specifies to which of the seven hardware priority
queues the
config scheduling
command will apply. The seven hardware
priority queues are identified by number, from 0 to 6, with the 0 queue being
the lowest priority.
max_packet <value 0-15>
−
Specifies the maximum number of packets the
above specified hardware priority queue will be allowed to transmit before
allowing the next lowest priority queue to transmit its packets. A value
between 0 and 15 can be specified.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the traffic scheduling mechanism for each queue:
DGS-3612G:4# config scheduling 0 max_packet 12
Command: config scheduling 0 max_packet 12
Success.
DGS-3612G:4#
show scheduling
Purpose
Used to display the currently configured traffic scheduling on the Switch.
Syntax
show scheduling
Description The
show scheduling
command will display the current traffic
scheduling mechanisms in use on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the current scheduling configuration:
DGS-3612G:4#show scheduling
Command: show scheduling
QOS Output Scheduling
MAX. Packets
-------------
Class-0 1
Class-1 2
Class-2 3
Class-3 4
Class-4 5
Class-5 6
Class-6 7
DGS-3612G:4#
97
