DVG-5112S User’s Manual
VoIP Telephone Adapter Configuration-IVR
D-Link Systems, Inc.
88
4. Configuring the VoIP Telephone Adapter through
IVR
VoIP transmits voice data (packets) via the Internet, hence the condition and status of the network environment is
relatively important to the telecommunications quality. If any one of the parties involved in VoIP communications
has insufficient bandwidth or frequent packet loss, the telecommunication quality will be poor. Therefore,
excellent telecommunication can only happen when the VoIP Telephone Adapters are connected to the Internet
and when the network environment is stable.
Preparation
1.
Connect the power supply, telephone set, telephone cable, and network cable properly.
2.
If a static IP is provided, confirm the correct IP settings of the WAN Port (IP address, Subnet Mask,
and Default gateway). Please contact your local Internet Service Provider (ISP) if you have any
question.
3.
If you are using ADSL (PPPoE) for your network connection, confirm the account number and
password.
4.
If you intend to operate the VoIP Telephone Adapter under NAT, the IP range of VoIP Telephone
Adapter WAN Port and LAN Port IP Address of your Router should not be the same in order to avoid
phone failures.
Basic Setup
The VoIP Telephone Adapter provides two setup modes:
1.
Telephone IVR Configuration Mode
2.
Browser Configuration Mode
IVR configuration provides basic query and setup functions, while browser configuration provides full setup
functions.
4-1 IVR (Interactive Voice Response)
The VoIP Telephone Adapter provides convenient IVR functions. Users are able to get query and setup the
VoIP Telephone Adapter with a phone-set and function-codes without turning on the PC.
Note:
When finishing the setup, make sure the new settings are saved. This will enable the new settings to
take effect after the system is restarted.
Instructions
FXS Port:
Connect to telephones. To access IVR mode, passwords should be entered, “* * password #”.
Alphabets to digits conversion information is provided in the PPPoE Character Conversion Table. When
correct IVR passwords are entered and accepted, an indication tone can be heard indicates the system is
in IVR setup mode. Enter function codes to check or configure the VoIP Telephone Adapter.
Example:
If your password is “1234”, enter
*
(star)
*
(star) 1 2 3 4 # (pound)
,
and now
you are entering IVR
setup mode. Next, enter a function code to check or configure the VoIP Telephone Adapter. If your
password is “admin”, enter
*
(star)
*
(star)
*
(star) 41 44 53 49 54 # (pound). Please refer to the IVR
