DGS-3312SR Gigabit Layer 3 Switch
all multicast traffic to any IP router.
Telnet Status
Telnet configuration is
Enabled
by default. If you do not want to allow configuration
of the system through Telnet choose
Disabled
.
Telnet TCP Port
Number(1-65535)
The Telnet TCP port number. TCP ports are numbered between 1 and 65535. The
"well-known" TCP port for the Telnet protocol is 23.
Web Status
Web-based management is
Enabled
by default. If you choose to disable this by
selecting
Disabled
, you will lose the ability to configure the system through the web
interface as soon as these settings are applied.
Web TCP Port
Number(1-65535)
The TCP port number currently being utilized by the Switch to connect to the web
interface. The "well-known" TCP port for the Web interface is 80.
RMON Status
Remote monitoring (RMON) of the Switch is
Enabled
or
Disabled
here.
GVRP
Use this pull-down menu to enable or disable GVRP on the Switch.
Link Aggregation
Algorithm
The algorithm that the Switch uses to balance the load across the ports that make
up the port trunk group is defined by this definition. Choose
MAC
Source, MAC
Destination
,
MAC Src & Dest, IP Source, IP Destination
, and
IP Src & Dest.
(See
Link Aggregation)
Switch 802.1x
Use this pull-down menu to enable or disable 802.1x functions on the Switch.
Syslog state
Use this pull-down menu to enable or disable Syslog functions on the Switch
Port Configuration
To configure basic port settings such as port speed, duplex, and learning state, use the
Port Configuration
window.
Click the
Port Configuration
link in the
Configuration
folder:
39
Summary of Contents for DGS-3312SR
