D-Link DGS-3312SR, Product Manual

Page: 126 / 244

DGS-3312SR Gigabit Layer 3 Switch
Parameter Description
IP Address < 0.0.0.0 > Allows the entry of an IP address that will be a static entry into the Switch’s
Routing Table.
Subnet Mask < 0.0.0.0 > Allows the entry of a subnet mask corresponding to the IP address above.
Gateway IP < 0.0.0.0 > Allows the entry of an IP address of a gateway for the IP address above.
Cost (1-65355) < 1> Allows the entry of a routing protocol metric representing the number of
routers between the Switch and the IP address above.
Backup Status Specify the route as Primary or Backup . If a single IP route is used, it is
unnecessary to change this. Designate a backup route if an alternate route is
desired. A backup IP route is sometimes called a “floating static route.”
Static ARP Settings
Use the Static ARP Settings window to create permanent entries in the ARP table for different IP interfaces. Static ARP
entries that have been configured appear in the Static ARP Settings table in this window. To add a new static ARP entry,
click on the
Add button, a new window appears (see below). To remove an existing entry, click the X button in the Delete
column for the entry you want to eliminate. To delete all static ARP entries, click the Clear All button.
Figure 5- 24. Static ARP Settings window
Clicking the Add button allows you to add a new entry using the window below.
Figure 5- 25. Static ARP Table – Add a New Entry window
Enter the IP address and the MAC address of the device you want to map with ARP and click the Apply button. The new
entry will appear in the Static ARP Settings window. Click the Show All Static ARP Entries link to see the Static ARP
Settings window.
RIP
The Switch supports the Routing Information Protocol (RIP).
RIP Global Setting
To setup Routing Information Protocol (RIP) for the IP interfaces configured in the Switch, open the RIP folder and click
on the RIP Global Setting link. Use the RIP Global Setting window to first enable RIP and then configure RIP settings
for the individual IP interfaces. To enable RIP, select Enabled from the drop-down RIP State menu and click the Apply
button. RIP can be disabled or enabled without changing any of the RIP IP interfaces settings using this window.
113