D-Link DGS-1100-06/ME, Cli Reference Manual

Page: 243 / 275

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
231
35
POWER SAVING COMMANDS
The Power Saving commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config power_saving mode [hibernation | led | length_detection | port] [enable | disable]
config power_saving
[hibernation | led [all | <portlist>] | port [all | <portlist>]] [add | delete]
time_range1 <range_name 20> time_range2 <range_name 20>
{clear_time_range}
show power_saving {hibernation | led | length_detection | port}
Each command is listed in detail, as follows:
config power_saving mode
Purpose To configure the power saving mode on the switch.
Syntax
config power_saving mode [hibernation | led | length_detection
| port] [enable | disable]
Description The
config power_saving mode
command is used to configure the
power saving mode on the switch.
Parameters hibernation
–
Configure the hibernation state to enable or disable.
The default value is disabled.
led
–
Configure the led state to enable or disable. The default value
is disabled.
length_detection
–
Configure the length detection state to enable or
disable. The default value is disabled.
port
–
Configure ports state to be enabled or disabled.
[enable | disable]
–
Enable or disable the power saving feature .
Restrictions Only Administrator or operator
–level users can issue this command.
Example usage:
To configure the power saving mode on the switch:
DGS-1100-06/ME:5# config power_saving mode port hibernation enable
Command: config power_saving mode port hibernation enable
Success!
DGS-1100-06/ME:5#
config power_saving
Purpose To configure the power saving on the switch.