D-Link DGS-1100-06/ME, Cli Reference Manual

Page: 119 / 275

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
107
16
QOS COMMANDS
The QoS commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config
bandwidth_control [<portlist> | all] {rx_rate [no_limit | <value 64-1000000>] | tx_rate [no_limit |
<value 64-1000000>]}
show
bandwidth_control
{[<portlist> | all]}
config qos mode [802.1p | dscp | portbased]
show qos mode
config cos
ipv6_tc_mapping
trafficclass <class_id 0-255> priority [high | highest | low | medium]
show cos
ipv6_tc_mapping
{trafficclasee <class_id 0-255>}
delete cos
ipv6_tc_mapping
d{trafficclasee <class_id 0-255>}
config
scheduling_mechanism
[strict | wrr]
show
scheduling_mechanism
config dscp_mapping dscp_value <value 0-63> priority [high | highest | low | medium]
show dscp_mapping {dscp_value <value 0-63>}
Each command is listed in detail, as follows:
config bandwidth_control
Purpose To configure bandwidth control on the Switch.
Syntax
config bandwidth control [<portlist> | all] {rx_rate [no_limit |
<value 64-1000000>] | tx_rate [no_limit | <value 64-1000000>]}
Description The config bandwidth_control command defines bandwidth
control.
Parameters portlist - A port or range of ports to be configured.
all - Specifies that the config bandwidth_control command applies
to all ports on the Switch.
rx_rate - Enables ingress rate limiting

no_limit
–
Indicates no limit is defined .

<value 64
–1000000>
]
–
Indicates a range between 64-
1000000 kbps.
tx_rate
– Enables egress rate limiting.