D-Link DGE-560SX User Guide
111
8.
If you want to configure LiveLink, select
Yes
, otherwise select
No
, then click
Next
.
9.
Select the probe interval (the number of seconds between each retransmission of a
link packet to the probe target) and the maximum number of probe retries (the
number of consecutively missed responses from a probe target before a failover is
triggered).
10.
Set the Probe VLAN ID to allow for connectivity with probe targets residing on a
tagged VLAN. The number set must match the VLAN ID of the probe targets as well
as the port(s) on the switch to which the team is connected.
Note: Each LiveLink enabled team can only communicate with Probe Targets on a
single VLAN. Also, VLAN ID 0 is equivalent to an untagged network. If the Probe VLAN
ID is set to a value other than 0, then a VLAN must be created with an identical VLAN
tag value (see Step 16.).
11.
Click the probe target at the top of the list, click
Edit Target IP Address
, type the
target IP address in the
IP Address
box for one or all probe targets, and then click
OK
. Click
Next
.
Note: Only the first probe target is required. You can specify up to three additional
probe targets to serve as backups by assigning IP addresses to the other probe
targets.
