21
COMMAND
Description and Parameters
ODD
[Odd
parity]
EVEN [Even
parity]
N5
= 1
[Stop Bits]
comsend N1
Transmit the specified ASCII data content over the serial port.
N1
= {ASCII data}
[ASCII text, up to 512 characters]
trigger status
Show the current state of all triggers on the unit.
trigger info
Show the current configurations of all triggers on the unit.
trigger info N1
Show the current configuration of the specified trigger.
N1
= 1~8
[Trigger port]
trigger mode N1 N2
Set the activation mode of the specified trigger.
N1
= 1~8
[Trigger port]
Available values for
N2
:
RAISING
[Trigger on low to high change]
FALLING
[Trigger on high to low change]
CHANGE
[Trigger on a change in state]
trigger active N1 N2
Enable or disable the specified trigger.
N1
= 1~8
[Trigger port]
Available values for
N2
:
ENABLE
[Enable
trigger]
DISABLE
[Disable
trigger]
Note: Commands will not be executed unless followed by a carriage return.
Commands are not case-sensitive.
Summary of Contents for CDPS-CS6
Page 1: ...Operation Manual Operation Manual Control System Center CDPS CS6...
Page 2: ......
Page 30: ......
Page 31: ......
