18
6.7 Telnet Control
Before attempting to use Telnet control, please ensure that both the unit and
the PC are connected to the same active networks.
Start your preferred Telnet/Console client, or use the built in client provided
by most modern computer operating systems. After starting the client,
connect by using the current IP address of the unit and port 23 (if the
communication port number used by the unit has not been changed
previously). This will connect us to the unit we wish to control and commands
may now be entered directly.
Note 1: If the IP address of the unit is changed then the IP address required
for Telnet access will also change accordingly.
Note 2: The default IP address is 192.168.1.50 and the default
communication port is 23.
6.8 Telnet Commands
COMMAND
Description and Parameters
help
Show the full command list.
?
Show the full command list.
help N1
Show details about the specified command.
N1
= {Command Name}
ipconfig
Show the unit’s current IP configuration information.
sipmode N1
Set the IP address assignment mode.
Available values for
N1
:
STATIC
[Static IP mode]
DHCP [DHCP
mode]
Summary of Contents for CDPS-CS6
Page 1: ...Operation Manual Operation Manual Control System Center CDPS CS6...
Page 2: ......
Page 30: ......
Page 31: ......
