19
COMMAND
Description and Parameters
sipaddr N1
Set the unit’s static IP address.
N1
= X.X.X.X
[X = 0~255, Static IP address]
snetmask N1
Set the unit’s static netmask.
N1
= X.X.X.X
[X = 0~255, Static netmask]
sgateway N1
Set the unit’s static gateway address.
N1
= X.X.X.X
[X = 0~255, Static gateway address]
telnet_timeout N1
Enable or disable the Telnet timeout.
Available values for
N1
:
ON
[Timeout
enabled]
OFF
[Timeout
disabled]
eth_fadefault
Reset the unit’s network settings to the factory defaults.
ver
Show the unit’s current firmware version.
fadefault
Reset the unit to the factory defaults.
reboot
Reboot the unit.
relay N1 N2
Open, close, or toggle the specified relay.
N1
= 1~4
[Relay port]
Available values for
N2
:
OPEN
[Open the relay]
CLOSE
[Close the relay]
TOGGLE
[Toggle the relay]
Summary of Contents for CDPS-CS6
Page 1: ...Operation Manual Operation Manual Control System Center CDPS CS6...
Page 2: ......
Page 30: ......
Page 31: ......
