Loading Media
Spectra II
34
Operating Manual
08.17
5.3 Loading transfer ribbon
NOTICE!
For the thermal transfer printing method it is necessary to load a
ribbon, otherwise when using the printer in direct thermal print it is
not necessary to load a ribbon. The ribbons used in the printer
have to be at least the same width as the print media. In case the
ribbon is narrower than the print media, the printhead is partly
unprotected and this could lead to early wear and tear.
Figure 12
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must be
cleaned using printhead and roller cleaner (97.20.002). For
detailed information, please see page 88.
The handling instructions for the use of Isopropanol (IPA) must be
observed. In the case of skin or eye contact, immediately wash off
the fluid thoroughly with running water. If the irritation persists,
consult a doctor. Ensure good ventilation.
1. Open the printer cover.
2. Open the printhead (F) by turning the pressure lever (E)
anticlockwise.
Spectra 216!
Pull centring plate (D) outwardly.
3. Load the transfer ribbon roll (A) with outer winding onto the
unwinding roll (C).
4. Place an empty ribbon roll on the rewinding roll (B).
5. Lead the transfer ribbon below the printhead (F).