Effective October, 2000
Page 11
Before proceeding, identify the section(s) within
the Step that apply to the Breaker being
Retrofitted.
Step 6:
Installing the Sensor Harness and DTA
Extension Harness
A. Connect the Sensor Harness to the proper
terminals on the Aux. CT Module. Refer to
Section 12 of the Retrofit Application Data,
supplied with the Retrofit Kit, for detailed wiring
specifications.
B. Using one of the screws from Step 5, connect
the green ground wire from the Sensor Harness
(with ring terminal) to the Aux. CT Module.
Note: The long tan and green wires are for
the Remote Neutral Sensor on a 4W Ground
Breaker. They should be removed if not
required for the Retrofit.
C. Install the supplied grommet in the hole near
the bottom right corner of the Breaker Back
Plate.
D. Route the Sensor Harness towards the right
rear of the Breaker and through the grommet
just installed.
E. Route the Sensor Harness along the right rear
of the Breaker Back Plate up to the Sensors.
Connect the ring terminals of the Sensor
Harness to the 3-Point Sensor Terminal Blocks.
Refer to Section 12 of the Retrofit Application
Data, supplied with the Retrofit Kit, for detailed
wiring specifications.
www
. ElectricalPartManuals
. com
