Effective October, 2000
Page 20
Scrap the Warning Label Plate and “L” Bracket.
Rotate the connector 90
°
then reconnect it to
the PT Module, as shown, using the original
hardware.
Mount the PT Module to the right-hand Trip Unit
Mounting Bracket, using the (2) .138-32
×
.375"
screws, (2) flat washers, and (2) lock washers
supplied. The Glass Poly Insulation Barrier must
be positioned between the PT Module and the
Trip Unit Mounting Bracket.
E. Mount the Trip Unit to the Trip Unit Mounting
Bracket Assembly, as shown, using the (4)
Brass Spacers, (2) .190-32
×
5.00" screws,
(4) flat washers, (2) lock washers, and
(2) nuts supplied.
F. Align the holes in the “L” shaped Trip Unit
Mounting Bracket with the holes drilled in the
Breaker Channel in the applicable Step 8-A.
Secure the Mounting Bracket to the Breaker
Channel using the (2) .250-20
×
1.00" bolts, (4)
flat washers, (2) lock washers, and (2) nuts
supplied.
Mount the Trip Unit Assembly to the pre-drilled
holes in the top of the “L” shaped Trip Unit
Mounting Bracket, installed in Step 8-B, using
the (2) .250-20
×
.750" bolts, (4) flat washers,
(2) lock washers, and (2) nuts supplied.
F. Align the holes in the Trip Unit Assembly with
the holes drilled in the right side of the middle
Breaker Channel in the applicable Step 8-A.
Secure the Trip Unit Assembly to the Breaker
Channel using the (2) .250-20
×
.750" bolts, (4)
flat washers, (2) lock washers, and (2) nuts
supplied.
www
. ElectricalPartManuals
. com
