![background image](http://html1.mh-extra.com/html/curtis/1kubzd1211pr/1kubzd1211pr_installation-and-owners-manual_2699821007.webp)
CAB INSTALLATION
7 of 30
Step 3: (Install ROPS Mounts)
3.1
Remove the left and right hand tension screws
and clips on the ROPS and discard.
3.2
Remove the ROPS pin and bolt from the left side
and discard. Leave the right side installed at this
time.
3.3
Remove the upper bolt on the cross hose
protector as shown and discard.
3.4
Install the left ROPS mount using the following
hardware. The large bolt in the pivot hole should
be tightened just enough so that the ROPS can
still tilt without damaging the paint. The large bolt
in the hole where the pin was removed should be
installed through the bracket, but no nut installed
at this time. Tighten the smaller M8 bolt at this
time.
Hardware Used
Qty
M16x2x80mm Hex Head Bolt
2
M16x30 Steel Flat Washer
3
M16x2 Locknut
1
M8x1.25x30mm Flange Bolt
1
3.5
Repeat steps 3.2, 3.3, and 3.4 for the right side.
3.6
Remove the lower M16 bolts from the previous
steps and tilt the ROPS back and re
-
use the bolts
to pin in the tilted position. Be careful not to
damage the engine hood if it is in the open
position. The nuts on the lower bolts will be
installed in a later step.
Fig. 3.6 (Tilt the ROPS)
Fig. 3.1 (Remove hand screws and ROPS Bolt)
Fig. 3.3 (Remove upper bolt)
Fig. 3.4 (Install Left ROPS Mount)
Remove
Remove
Remove
Bolt Only
ROPS
Mount