CAB INSTALLATION
10 of 30
4.10
Flip the seat forward and install the supplied
adhesive Velcro as shown. Be sure to wipe down
the surfaces where the Velcro will be adhered and
that the surfaces are at room temperature.
Apply between round seat bumpers
Apply along horizontal edge of fenders
Apply 3 sections underneath front seat support
frame member as indicated by dotted line. Velcro
must be on the underside.
Step 5: (Cabin Installation)
5.1
Lower the seat and slide the seat all the way
forward and use the knob on the seat to tilt the
seatback forward as much as possible.
5.2
Remove the doors from the cabin and set aside
carefully to prevent scratching the panels.
5.3
Remove the 3 bolts securing the compressor
bracket to the base of the shipping mount and cut
any zip ties holding the hoses and wire harness to
the shipping mount. Support the compressor
using a bungee cord or rope. Do not ever use the
hoses to support the compressor or damage may
occur.
5.4
Position a lifting strap where shown so that it sits
roughly
2”
in front of the b
-
pillar.
Fig. 5.4 (Position lifting strap)
Fig. 4.10 (Install Velcro)
Fig. 5.1 (Move Seat forward, Rotate seatback)
Fig. 5.3 (Unbolt Compressor)