CAB INSTALLATION
13 of 30
Step 6: (Compressor Installation)
6.1
Loosen the lower and upper pivot bolts that are
securing the compressor to its mounts.
6.2
Move compressor into location on the left side of
the engine and secure the bracket with the
hardware listed below as shown in figures 6.2a
and 6.2b.
Hardware Used
Qty
M10x1.25x30mm Flange Bolt
3
6.3
Align the pulley on the compressor with the pulley
on the dynamo using a steel straight edge and
tighten the three mounting bolts installed in step
6.2.
6.4
With the compressor tilted all the way out in its
adjustment slot, re
-
connect the two ring terminals
to the stud on the starter and re
-
install the
additional wire into the connector on the starter.
Torque the stud to 5.9 to 11.8 Nm (4.3 to 8.7 lbf
-
ft)
Note: Be sure that none of the wires or terminals
are touching the steel compressor bracket after
tightening the starter nut! Ensure protective boot
is re
-
installed.
6.5
Install the supplied belt and tension. Tighten all
compressor pivot bolts at this time.
Fig. 6.2a (Secure Compressor with 2 Bolts in Rear)
Fig. 6.2b (Secure Compressor with 1 Bolt in Front)
Fig. 6.4 (Re
-
Attach Starter Wires)
M10
Bolts
M10
Bolt
Ensure
Clearance
Fig. 6.5 (Install Belt and Tension)
Belt