CAB INSTALLATION
6 of 30
2.6
Hang the double dynamo setup onto the vehicle
with the OEM dynamo back into its original
location with the threads on the previously
installed bolt protruding through the upper dynamo
adjustment slot. Install a nut onto the end of the
bolt, but do not tighten.
Hardware Used
Qty
M8x1.25 Flange Locknut
1
2.7
Install the same thickness shim washer as was
used on the upper ears (step 2.5) between the
lower pivot mount and secondary dynamo. The
dynamo shaft may need to be rotated to allow the
shim to fit.
Install the lower pivot bolt from the front side of the
OEM dynamo. With a lock washer and then a flat
washer under the head of the bolt, pass through
the smooth hole in the OEM dynamo, through the
ear on the engine, through the appropriate
thickness stainless steel shim washer, and thread
into the secondary dynamo ear. Tighten the bolt
and then back off 1/2 turn.
Hardware Used
Qty
M8x1.25x65mm Hex Head Bolt
1
M8x16 Steel Flat Washer
1
M8x14 Split Lock Washer
1
13/16 x 11/32 SS Shim x
.015”, .030”, .048”
or
.062”
Thick
1
2.8
Tighten the upper dynamo bolt only, at this time.
Do not tighten the upper dynamo nut.
2.9
Re
-
install the OEM belt onto the OEM dynamo
and tension. Tighten nut on the upper dynamo
bolt first then the lower pivot bolt. Note: hold the
head of the upper bolt while tightening the nut.
Fig. 2.6 (Hang Dynamo
’
s, Install Locknut)
Fig. 2.7 (Install Pivot Bolt and Washer)
Fig. 2.8 (Tighten Upper Bolt)
Stainless
Shim
Locknut
Tighten
Upper Bolt
Fig. 2.9 (Re
-
Install Belt)
Tighten
Nut
Tighten
Bolt
Hold Bolt
Head