CAB INSTALLATION
19 of 30
9.4
Assemble the rear shroud panel and cover
together as shown. Leave the bolts loose at this
time.
Hardware Used
Qty
1/4
-
20x3/4
”
Flange Bolts
3
9.5
Assemble the rear shroud panel to the vehicle.
Tighten all shroud bolts at this time.
Hardware Used
Qty
1/4
-
20x3/4
”
Flange Bolts
6
Step 10: (Filler Installation)
10.1
Raise the seat and install the rubber underseat
filler panel as shown. Start by aligning the panel
over the round rubber bumpers that the seat rests
on and work around the perimeter to attach to the
pre
-
installed Velcro.
10.2
Install Velcro around the perimeter of the
underseat filler in the areas where Velcro was not
pre
-
installed using the filler as the locating
template for the Velcro. Be sure to wipe down the
surfaces where the Velcro will be adhered and
that the surfaces are at room temperature.
10.3
Lower the seat, slide the seat completely forward,
tilt seat back forward, and install adhesive Velcro
to the seat base so that it is located up against the
stamped rib as shown.
Fig. 9.4 (Assemble Cover Panel)
Fig. 9.5 (Install Shroud over Compressor)
Fig. 10.1 (Install Underseat Filler)
Fig. 10.3 (Install Velcro)
1/4”
Bolts
1/4”
Bolts
Align
Back of Seat
Velcro