![background image](http://html1.mh-extra.com/html/curtis/1297/1297_manual_2699565087.webp)
Curtis PMC 1297 Manual
79
Preliminary on Verso page is set with right edge at 7 and 7/8,
and the top (as on the Recto page) at 1/4.
VARIABLE BRAKE
Braking proportional to opposite-direction throttle: on/off
TAPER RATE
Threshold affecting end of regen during direction reversal: 1–20
INT OVERRIDE
Special operation with interlock switch open: on/off
H/S LATCH
Momentary-type mode switch electrically “latchable” in M2: on/off
ANTI-TIEDOWN
Anti-tiedown: on/off
THROTTLE TYPE
Throttle input signal type
1
THROTTLE DB
Neutral deadband, as % of throttle range
THROTTLE MAX
% of throttle movement at which 100% output occurs
THROTTLE MAP
Throttle map, as % output at half throttle
POT LOW CHECK
Traction throttle fault detection (at J1 Pin 4): on/off
FIELD MIN
Traction motor min. field current, in amps
FIELD MAX
Traction motor max. field current, in amps
FIELD MAP
Field current at midpoint of armature current, in %
FLD MAP START
Armature current at which field current starts increasing, in amps
FIELD CHECK
Traction motor field check: on/off
RESTRAINT
Braking applied in restraint situation, in amps
CURRENT RATIO
Current-to-throttle ratio: 1 (1
×
), 2 (2
×
), 3 (4
×
), or 4 (8
×
)
BOOST ENABLE
Boost current option enabled: on/off
LOAD COMP
Load compensation: 0 to 25%
SEQUENCING DLY
Sequencing delay, in seconds
SRO
Static return to off (SRO) type
3
HPD
High pedal disable (HPD) type
2
MAIN CONT INT
Main contactor control type
4
MAIN OPEN DLY
Delay after interlock opens, in seconds
MAIN CONT DIAG
Main contactor diagnostics enabled: on/off
E-M BRAKE TYPE
Electromagnetic brake driver type
5
E-M BRAKE DLY
Delay after interlock switch opens, in seconds
EMR REV CHECK
Emergency reverse wiring check: on/off
EMR REV C/L
Emergency reverse current limit, in amps
EMR ACCEL RATE
Emergency reverse acceleration rate, in seconds
EMR DIR INT
Emerg. rev. exit by cycling dir. switches
or
intk: on/off
6
EMR TIME LIMIT
5-second time limit for emergency reverse: on/off
PUMP C/L
Pump motor current limit, in amps
PUMP LOCK C/L
Pump motor current at which Lift is locked out, in amps
PUMP LOCK DLY
Time before Lift locked out in overcurrent, in seconds
NO LOAD C/L
Pump motor current that defines “load,” in amps
PUMP ACCEL
Pump motor acceleration rate, in seconds
PUMP DECEL
Pump motor deceleration rate, in seconds
HYD THRTL TYPE
Hydraulic throttle input signal type
7
HYD THRTL DB
Neutral deadband, as % of hydraulic throttle range
6 — PROGRAMMER MENUS: Program Menu
Program Menu,
cont’d
(Menu continues on next page.)