Cumberland 074-11772, Owner'S Manual

Page: 27 / 102

3
Basic connections
Topics Covered in this Chapter
▪ Preparing the enclosures for installation
▪ Connecting the Power Supply
▪ Connecting the EDGE Bin Scale to the communication network
▪ Connecting a loadcell
▪ Grounding
▪ Wiring Connections
Preparing the enclosures for installation
The Bin Scale module will need holes drill into the bottom to allow the installation of cable connectors or
conduit to the enclosure.
Before You Begin
NOTE: Up to 1 inch (25.4mm) rigid conduit can be used for the EDGE Bin Scale.
1. Remove the four screws from the cover of the Bin Scale module.
2. Drill a hole the size of the your cable connector or your rigid conduit through the bottom side of the
enclosure.
3. Remove all plastic fragments.
4. Install the cable connector or rigid conduit adaptor to the bottom of the enclosure.
IMPORTANT: All cable connectors or conduit must be water tight.
5. Install the Bin Scale module cover using the four screws.
After You Finish
You will need to mount the Bin Scale module. Refer to Guidelines on the ideal location for installation,
Clearance around the Bin Scale module and Mounting the Bin Scale Module sections in this manual.
891–00577 EDGE Bin Scale 3 Wires LC 27