Cumberland 074-11772, Owner'S Manual

Page: 45 / 102

6
Setup
Topics Covered in this Chapter
▪ Setting up a Bulk Feed Tank
▪ Setting up a Tank group
▪ Setting an Out of Feed Alarm
Setting up a Bulk Feed Tank
From the EDGE Controller , you can set the parameters for each tank.
To setup the bulk feed tank parameters: (See )
1. Press the Setup icon on the EDGE Controller .
2. Select Outside from the Room/Barn drop down menu.
3. Press Bulk feed tank .
4. Select Room Setup .
5. Select the tile of the Bulk feed tank that you want to setup.
NOTE: The Bulk feed tank tile shows the name of the tank and the current feed weight in the tank.
6. Set the the following parameters:
Parameter Description
Minimum feed
delivery The minimum feed weight added to the tank to be considered as a feed delivery.
Any added weight under this entered value will not trigger a feed delivery notice.
Filling delay The maximum time between feed weight increments to be considered as a single
delivery.
A weight increment will start a countdown with the entered value. If a new incre-
ment is detected, it will reset the countdown. If no increment is detected before the
end of the countdown, the feed delivery will be considered complete and a delivery
notice will be sent.
Use feed order
notification Check this field if you want to be notified when it’s time to order feed for this tank.
Order
notification If the above Use feed order notification is checked, enter the feed weight value to
trigger the notification.
The notification icon will flash with a number in it and a notification will be sent to
the selected contacts.
For more information, see the
User management section in the EDGE Controller
manual.
Part of tank
group Appears only if at least one tank group is already configured. Select the tank
group from the drop down list if you want this tank added to tank group. See Set-
ting up a tank group section in this manual.
891–00577 EDGE Bin Scale 3 Wires LC 45