Cumberland 074-11772, Owner'S Manual

Page: 39 / 102

5
Configuration
Topics Covered in this Chapter
▪ Configuring a Bulk Feed Tank
▪ Calibrating the Bin Scale
Configuring a Bulk Feed Tank
You have to configure a bulk feed tank in the EDGE Controller so the Bin Scale Modules can be properly
identified and calibrated.
Before You Begin
• Make sure the loadcells and Bin Scale Modules are installed correctly.
• Make sure all electrical connections are installed correctly.
• Make sure the software version used on the EDGE Controller is 2.4.0 or higher. See EDGE Control-
ler user manual for more information on how to check the software version.
• Make sure that an outside service room has been setup. A bulk feed tank can only be configured in
an outside service room. To configure an outside service room, see Room/Barn configuration in
the EDGE Controller manual.
• Make sure that the Bin Scale Modules has been detected by the EDGE Controller . See the Module
detection section in the EDGE Controller manual for more information.
• Make sure you know the name of the tank and the Bin Scale Modules .
To add and configure a bulk feed tank:
1. Press the Configure icon on the EDGE Controller .
2. Select Outside from the Room/Barn drop down menu.
3. Press Bulk feed tank .
4. Press the button to add a new tank or choose an existing tank to modify.
891–00577 EDGE Bin Scale 3 Wires LC 39